How To Install H4 Bi Xenon Hid Kit

Bi-Xenon HID Conversion Kit Installation Guide

Other Guides:

Standard Kit (Unmarried Axle)
Single beam (With Relay)
Hi/Lo (Xenon Lo-beam/Halogen Hi-beam)

NOTE: Never touch the bulb with your easily and keep them every bit make clean equally possible. Also, it is strongly recommended yous use dielectric grease in all of the connections – it volition help secure a better electrical connection.

Disconnect the negative terminal of your automobile battery.
Disconnect your stock bulbs and remove them from the light housing.
Install the HID bulb into the light housing and connect the HID bulb to the wire coming out of the anchor
Mount the ballast to the engine compartment with the brackets provided, where is not as of import as long every bit information technology is secure. You lot should too accept the subclass mounted vertically so the ballast does not have the potential to autumn out with a hard bump or excessive vibration. Some people will apply cipher ties to further secure the ballast horizontally, although this is not necessary in nigh cases.
Remove the fuse from the relay harness.
Connect the negative (black) wire to a grounded connection on your vehicle (this assumes your vehicle is grounded negative). If possible, practise not connect this wire directly to your battery.
Connect the cherry-red wire to the positive (cherry) concluding of your bombardment.
Connect the adapter from the closest headlight wire of your car's system into the input on the harness. The other side will remain unplugged simply should be capped with electric tape to keep from being exposed.
Connect the Hi-Beam switching cable between the harness and the low-cal bulb.
Connect the anchor leads to the two ballasts.
Secure whatever loose wiring with zip ties or insulation.
Replace the fuse on the relay harness.
Connect the battery and test the lights to make certain they piece of work correctly.

After Installation: Once everything checks out, you will desire to aim your headlamps slightly down. The increased low-cal output coming from a reflector housing could interfere with oncoming traffic. If you feel any flickering, double check your connections and contact Client Support. If yous have whatsoever other bug, contact us for troubleshooting.